crashhard

Mini Statistics

Join Date: 07-27-2007

Last Activity: Today 08:46 AM

Avatar

More 25 Friends

Recent Visitors

The last 10 visitor(s) to this page were:

This page has had 34,314 visits

Tab Content: Visitor Messages; About Me; Friends; Post Areas

34 Visitor Messages

Nickeljet - 06-05-2013 05:18 PM View Conversation

I do want the 3 flame arrestor elements for the Kawasaki Ultra 150 if you still have them.
Chris gp1200r - 11-12-2012 05:29 AM View Conversation

Hey buddy. Sorry to mess you about. But. I just seen a lot more damage to my engine. So would it be possible to cancel my order and get a refund till I can sus out what else I need. Then I'll get back to you.
Sorry again.
Chris gp1200r - 11-12-2012 03:23 AM View Conversation

Hey can you please delete your pms. I cant message you. Please contact me before sending my powervalve clips.
RIVERA RACING - 09-10-2012 08:09 AM

2003 gp1300 part out......is the motor good..PM me your PM is full
The Reaper - 09-10-2012 07:22 AM

Other than the ding it doesn't effect anything correct? Spins fine and bearings are good? Its going in my GPRSHO Your PM box is full
Will
Bigwilk - 06-25-2012 09:03 AM

Hey Joe, I'll take the exhaust.. Check your PM's..
ALOHR - 03-22-2012 10:27 PM View Conversation

Whats your offer
GTLaser - 02-20-2012 02:11 PM View Conversation

Clear your messages... they are full...
ctct2118 - 01-13-2012 04:37 PM View Conversation

clear some of those messages your full
pauladave - 09-25-2011 04:14 AM View Conversation

Hi Joe. Did you get a chance to measure a 1200Ltd driveshaft (66V-45511-00-00), as I'm seeing an engineer friend this week, and could ask his advice on welding a piece in if I know the length (though I'm not really keen on that option)? Do you have a really good one, and how much do you want for it, shipped to UK? Thank's for your help, & regards, Dave