crashhard

Hey buddy. Sorry to mess you about. But. I just seen a lot more damage to my engine. So would it be possible to cancel my order and get a refund till I can sus out what else I need. Then I'll get back to you.
Sorry again.

Hey can you please delete your pms. I cant message you. Please contact me before sending my powervalve clips.

2003 gp1300 part out......is the motor good..PM me your PM is full

Other than the ding it doesn't effect anything correct? Spins fine and bearings are good? Its going in my GPRSHO Your PM box is full
Will

Hey Joe, I'll take the exhaust.. Check your PM's..

Whats your offer

Clear your messages... they are full...

clear some of those messages your full

Hi Joe. Did you get a chance to measure a 1200Ltd driveshaft (66V-45511-00-00), as I'm seeing an engineer friend this week, and could ask his advice on welding a piece in if I know the length (though I'm not really keen on that option)? Do you have a really good one, and how much do you want for it, shipped to UK? Thank's for your help, & regards, Dave

Hi Joe. PaleRider says you may have a good intermediate shaft (part# 66V-51323-01-00) for a 1999 XL 1200Ltd. Can you help, and ship to UK? Thank's, dave.