Search:

thanks

I have the software, i am just trying to find or make a cable to test and reset codes

I have the manual and version 1.3 of KADIAG. I just need the cable (57001-1460), the cheapest cable I found was $142.00

Does anyone know the wiring for this cable to make my own?
my computer...

yes motor turns, i just did the top end, 130 in all cylinders. temp sensors are all plugged in, if I take them out the alarm will sound.
all grounds have been double checked. I am going to go to...

no one? I have found many seadoo and yamaha diagnostics, but no kawasaki for my DI

I had the same issue. I changed the crank sensor and it started right up. although i now have a check engine light on and need to pull codes

I rebuilt the topend and carbs on my 2001 XLT and now can not get it to start.

I have a battery charger hooked up to it set at 50amps but it will not turn the starter, so i crank it up to...

where is the best place to get KADIAG and a cable for a 2000 STX DI ?

I had DFI rebuild my EMM and I replaced the TPS and the CPS

the ski starts and runs but I am getting a check engine light...

thanks
I replaced the crank sensor and the ski runs. my only problem now is i get a check engine light warning.
the ski idles at 2500rpm

I do not have a kawi dealer close, so i am going to have...

is this only for 2 cyl or also 3 cyl ?

my 2000 STX DI wont run. I had the EMM rebuilt from DFI , I replaced the TPS sensor, new spark plugs , I have fuel coming to the injectors and to the return. They ski will start and run if i dump...