07-15-2009, 08:00 PM #1
HELP : O Ring where Does It Go.....
Guys i had to change my rubber boot and bearing that goes on the end of the engine that the shaft goes into.
I ordered the new rubber boot that came with the bearing attached (thanks Jerry) there was was a seal that i orderered as well which i am not usre i need but ordered it anyway it look like it belong there as well.
part No 44
When i pulled the shaft out it all came off with the rubber boot but no seal anywhere.
I am guessing this O ring sits inside the engine side which has not come out so i don t need to install it or is it wise to replace and how hard is it to get out.
Heres a few pics of the O ring and boot
07-15-2009, 08:07 PM #2
The O-ring goes inside the bearing..There should be 2 O-rings..According to the diagram and part number, that is the seal for the inside of the bearing...
07-15-2009, 08:11 PM #3
07-15-2009, 10:32 PM #4
07-15-2009, 10:57 PM #5
I replaced all my drive setup and from what i remember the boot comes with bearing and everything intack. I did not add any o ring.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Polaridoo in forum 2-Stroke PerformanceReplies: 5Last Post: 07-30-2010, 07:19 PM
By NetBret in forum Sea Doo Open DiscussionReplies: 10Last Post: 06-04-2010, 09:28 PM
By ppezzolla in forum 2-Stroke PerformanceReplies: 6Last Post: 05-17-2009, 05:30 PM
By Pale Rider in forum Open DiscussionReplies: 2Last Post: 12-30-2006, 12:52 PM
By DeeGee in forum Sea Doo Open DiscussionReplies: 3Last Post: 07-02-2006, 09:19 AM