07-17-2009, 12:55 PM #1
Stripped out part of exhaust stay... any suggestions?
I stripped out the section of p/n # 74 where bolt p/n # 75 would go. Reference diagram:
Anyone have any ideas? Could I tap it for a bigger bolt and use that? Is it even necessary? Exhaust feels really stiff already. Thanks in advance.
07-17-2009, 02:15 PM #2
drill it all the way thru and use a longer bolt with a washer/nut
07-17-2009, 02:49 PM #3
You can also heli coil it ,if you so desire.
07-17-2009, 03:02 PM #4
07-17-2009, 03:14 PM #5
I've stripped the same exhaust bracket before. I just used my tap n die kit and it worked perfectly.
07-17-2009, 04:47 PM #6
07-17-2009, 07:25 PM #7
I used the tap n die kit to re-thread the stripped part. Took a few minutes and put the bolt back in with some thread locker and it was done.
07-17-2009, 10:16 PM #8
- Join Date
- Jun 2008
- Hillsborough, North Carolina
Wow!,,,, check out the price of this thing!
I just looked under the OEM parts finder, that stay is like $91.+ S&H...!!!
Good Save !!!!!!
07-18-2009, 10:41 AM #9
07-18-2009, 06:51 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By codymouse54321 in forum Sea Doo ClassifiedsReplies: 27Last Post: 06-16-2011, 08:21 AM
By pb0000 in forum MSX/MatrixReplies: 2Last Post: 06-09-2010, 11:12 AM
By Jkunzy1690 in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 06-03-2009, 05:09 PM
By MJE in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 05-19-2009, 07:40 AM
By Gforce in forum 4-Tec PerformanceReplies: 13Last Post: 07-03-2005, 12:46 AM