07-20-2009, 09:18 PM #1
Ok, How Do I keep Water Out of The VTS ??
I replaced the VTS motor because it locked up from get'n water in it. Took it out to the river last week, took it back out today (for some maintenance & bilge install). I couldn't believe how much water was in there.
What must I do to keep the water out to prevent it from ruining this motor from water intake?
07-20-2009, 09:23 PM #2
07-20-2009, 11:40 PM #3
- Join Date
- Aug 2005
- Jerry's guest bedroom
Replace boot and clamps. Some people silicone it up real good also.
07-21-2009, 12:59 AM #4
07-21-2009, 08:30 AM #5
Perhaps you forgot the rubber washer under the plastic bolt that holds the VTS in place.
07-21-2009, 09:00 AM #6
07-21-2009, 11:06 AM #7
I was thinking about doin the motor also, in areas i think water could get in.
What about the "box" the motor is in ? I'd like to, but at the rate i'm pulling this system apart not sure it's a good idea yet.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By faredo in forum Open DiscussionReplies: 21Last Post: 05-16-2013, 09:42 AM
By skigolfnut in forum 4-Tec PerformanceReplies: 19Last Post: 05-09-2011, 10:15 PM
By SLASHER in forum 4-Tec PerformanceReplies: 13Last Post: 10-05-2009, 06:29 AM
By Davpmars in forum 2-Stroke PerformanceReplies: 18Last Post: 05-08-2009, 06:24 AM
By BrAinZ in forum Sea Doo Open DiscussionReplies: 8Last Post: 06-02-2006, 09:03 PM