07-23-2009, 04:28 PM #1
Broken pulse line fitting on SBN44.. Fittings available?
Just go my 2 SBN44's for Blaster #1 today. The last real peice of the puzzle keeping it out of the water.
Problem is our great USPS somehow must have dropped the box and it looks like the 2 carbs "touched" each other. This caused my pulse line fitting on one carb to snap clean off at the base.
Can I buy just a fitting, or do I have to buy the whole pump outer body?
Anyone have the fitting for sale? Or the plate to the pump?
07-23-2009, 05:06 PM #2
Drill, tap, thread in a brass fitting with the appropriate thread sealant. Done!
07-23-2009, 05:18 PM #3
I don't know if this will help, but you can get these from Hot Products USA.
Last edited by XL1200Ltd-Keith; 07-25-2009 at 10:48 AM.
07-23-2009, 05:34 PM #4
07-23-2009, 05:47 PM #5
I found the plate for $12.99. Maybe I will just order a new one. Unless I can find a good used one.
07-23-2009, 06:18 PM #6
07-23-2009, 06:42 PM #7
Once I got over being pissed off at it, I thought about it.
Took an old 61x intake, heated around the pulse fitting, and it slid right out.
Fitting in now in freezer while I pull out broken one in carb. Once that is out, I will slide in the frozen fitting into the carb.
Now to figure out my throttle shaft problem. See post in 2 stroke section.
Thanks all for the help.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By oneeyedjack in forum 2-Stroke PerformanceReplies: 7Last Post: 04-14-2008, 04:07 PM
By RDH in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 01-06-2008, 01:06 PM
By mrbtd in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 01-05-2008, 11:56 PM
By DTV in forum Yamaha Old School SkisReplies: 29Last Post: 07-20-2007, 03:28 PM
By lodough780 in forum Polaris Open DiscussionReplies: 10Last Post: 05-24-2007, 04:59 PM