Thread: Removing stock GPR grips
07-26-2009, 12:02 PM #1
Removing stock GPR grips
Bought some new dpi grips, how do I get the old ones off?
07-26-2009, 12:08 PM #2
Take the end cap off the bars......Then cut length wise through the grip and peel off.
Give Rich a Bitch Slap for me!
OH welcome to the GH!
07-26-2009, 12:30 PM #3
welcome to the forum Dave
07-26-2009, 04:17 PM #4
07-27-2009, 07:15 AM #5
- Join Date
- Oct 2006
might as well replace the stock bars while you are at it
07-27-2009, 05:06 PM #6
Glad I measured before I cut, seems like the grips dont wanna fit over the trim tube on the handlebar, at least it LOOKS that way to me. Don't know why, I saw these grips hanging on the wall in rich's shop, figured they would fit.
07-27-2009, 05:10 PM #7
07-27-2009, 05:14 PM #8
yeah mine are odi too, but i think there atv grips maybe.
07-27-2009, 05:42 PM #9
They are the same. The pwc ones just use aluminum and stainless hardwareto prevent rust. They will fit just not over the white trim control tube. You need to cut this off.
I would go with aftermarket bars, a riva drop nozzle kit, and primer. This makes you bars look real clean with no clutter.
07-27-2009, 05:45 PM #10
now with an auto-drop can you trim it up past neutral or once the handle is released is this as high as the nose is going to get?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 4life in forum 2-Stroke PerformanceReplies: 7Last Post: 11-02-2010, 06:41 PM
By Chrisrokc in forum Yamaha Open DiscussionReplies: 6Last Post: 02-19-2007, 12:04 AM
By WATER WOODY in forum Yamaha Open DiscussionReplies: 5Last Post: 01-21-2006, 02:00 AM
By 01xdime in forum 4-Tec PerformanceReplies: 0Last Post: 11-12-2005, 10:13 PM
By orc in forum 4-Tec PerformanceReplies: 3Last Post: 05-13-2005, 04:08 PM