07-27-2009, 08:32 AM #1
Steering nozzle will not zero after putting on riva drop nozzle kit.
I installed the riva drop nozzle kit. I know how to adjust the QSTS up front in the pulley area. As the tightest setting possible in that area, the nozzle is still off by .3"
How large an impact will that .3" make?
Any ideas for how to fix it?
I saw the area in the back of the ski where the QSTS cable hooks up to the nozzle. In that area, there is also some threading. I loosened the lock nut, but it does not appear that the end can actually be adjusted. Can it?
Thanks to everyone in advance.
07-27-2009, 03:50 PM #2
07-27-2009, 03:54 PM #3
Yes the end at the nozzle can be adjusted they get stuck from corrosion.
07-30-2009, 10:34 AM #4
how much speed am I leaving on the table right now?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By tacomaguy00 in forum 4-Tec PerformanceReplies: 32Last Post: 10-05-2013, 07:28 AM
By Blue MSX 140 in forum MSX/MatrixReplies: 13Last Post: 01-03-2012, 08:48 AM
By minthill in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 02-06-2011, 07:44 PM
By friscoboater in forum Polaris Open DiscussionReplies: 3Last Post: 10-10-2010, 06:47 PM
By spgibson in forum Polaris How To & FAQsReplies: 4Last Post: 08-26-2010, 10:17 PM