07-30-2009, 08:20 PM #1
rouge plug with nothing to plug into
i am using an 05 rxt motor/gauge/harness in my gpr conversion. i have everything hooked up correctly on the harness except for the one male plug (2pin) that comes directly off the gauge cluster. it only extends about 6 inches from the cluster and i cannot figure out where to plug it in. there are no female plugs left and certainly nothing within the vicinity of the gauge cluster. the oem drawings say it goes to temp sensor.
RXT didn't have air temp in the gauge? i dont remember. why would they leave a wire there just hanging?
there should be an actual temp sensor it plugs into that mounts somewhere in the hull
i have cut something out of the wiring when doing the start stop switch mod to convert to yammi switch housing. this doesn't make a lot of sense though coz i would have known if a female plug just got cut off and i can trace all of my wires to something.
07-30-2009, 08:45 PM #2
07-30-2009, 09:38 PM #3
right, but i don't remember their being a sensor or where it even mounted on the rxt. i see the oem part is 65$
will i get a bunch of beeping if i leave it unhooked temporarily so i can get the show on the road with my final assembly and water test?
07-30-2009, 09:39 PM #4
by the way thanks again. this is the second time you have bailed me out in the last 2 weeks!
07-31-2009, 07:23 AM #5
07-31-2009, 07:59 AM #6
it will beep without the sensor, but the dealer can shut it off in buds. The sensor is usuallu mounted to the hood. on teh rxp it is directly in front of teh latch. it's black and pointy. mounted with a grommet.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By longone1984 in forum 2-Stroke PerformanceReplies: 1Last Post: 05-21-2010, 10:37 AM
By sportman in forum Kawasaki PWC Performance (4-stroke)Replies: 6Last Post: 06-07-2009, 02:24 AM
By gianni57 in forum Polaris How To & FAQsReplies: 8Last Post: 07-30-2007, 11:35 PM
By Bryan K in forum Yamaha PWC Performance (2-stroke)Replies: 23Last Post: 03-18-2007, 12:40 PM
By Jarrett in forum 4-Tec PerformanceReplies: 3Last Post: 05-25-2005, 07:22 AM