Thread: IC Pisser ??
08-05-2009, 10:21 AM #1
IC Pisser ??
I want to add an pisser out the side/back of my RXT that is directional. This will be used as an outlet for my IC. I've split my water ways. I don't want to use the outlet down in the pump area because I want to be able to see the water exiting so I know the IC is getting water.
I thought I remember seeing one someone had that could angle. I'd like the water to be visible from the drivers seat and I was hoping to have the water outlet higher than the IC so it would help keep the core full of water.
Any ideas ?
08-05-2009, 11:18 AM #2
this is what I did.........
08-05-2009, 12:58 PM #3
I have a 3/8 fitting on the front and back top corners of my IC which join at a T fitting and then a single 3/8 line to the front of the ski which goes to a hot products 45 degree 3/8 bubble fitting. I think they're like $8. 45 degrees is just right. You can aim it down a little bit and you can see it clearly without having wind blow it back in your face.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By TorquePhoto in forum 4-Tec PerformanceReplies: 22Last Post: 11-15-2006, 09:36 PM
By ABBOTT in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 09-20-2006, 02:46 PM
By 05RXPnoob in forum Yamaha Open DiscussionReplies: 6Last Post: 07-30-2006, 05:03 PM
By ccassone in forum 2-Stroke PerformanceReplies: 4Last Post: 02-22-2006, 10:42 PM
By ramnj in forum Sea Doo Open DiscussionReplies: 7Last Post: 10-06-2005, 12:12 PM