Thread: SHO boost reference
08-05-2009, 03:05 PM #1
SHO boost reference
Anybody have pictures of where your pulling boost reference and how much boost to expect on a stock motor??
08-05-2009, 05:30 PM #2
If not that, then you just drill and tap the manifold for 1/8th NPT and screw in a barb fitting.
Not sure about boost on a stock motor, probably around 6 psi. I saw 7.5 for breif periods (before the boost limiter kicked in) with the FF exhaust, RIVA intake, and manifold upgrade installed.
08-05-2009, 05:33 PM #3
08-05-2009, 05:38 PM #4
The easiest way without tapping the manifold is to use the R&D adaptor. With only the power filter & manifold sleeve installed I was seeing between 7.5-8.0 depending on weather. However, without the powershot or aftermarket ECU to eleiminate the boost limiter that is only sustainable for several seconds before the TB closes & drops it to 7.0-7.1.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Biggsw784 in forum 4-Tec PerformanceReplies: 8Last Post: 06-10-2013, 08:49 PM
By rossnemo in forum Yamaha ClassifiedsReplies: 0Last Post: 08-15-2011, 12:38 PM
By FullTilt429 in forum 4-Tec PerformanceReplies: 4Last Post: 02-27-2011, 01:50 PM
By Green Hulk in forum Yamaha PWC Performance (4-stroke)Replies: 70Last Post: 08-29-2009, 05:02 AM
By allstar71 in forum Yamaha PWC Performance (4-stroke)Replies: 55Last Post: 02-25-2009, 07:23 AM