Results 1 to 2 of 2
  1. #1

    Join Date
    May 2007
    Minneapolis MN

    Can a trim motor slip under load?

    My Pro1200 is showing some odd handling characteristics. Every once in a while when coming off a wave the hull will drive itself. It feels like a sponson got damaged and is dragging. The throttle response is also deadened, like too much of the hull is in the water. When I trim up, the jet spray shoots in the air but I'm thinking the trim motor is not holding the nozzle in position. I have dissassembled the trim and steering nozzle and the bushings have play but there were no loose bolts. Any ideas?

  2. #2
    AWA Member 32DegH2O's Avatar
    Join Date
    Aug 2006
    Minneapolis, Mn.
    Where in Minneapolis are you located?...I'm in Eagan...I could stop by and look at it for you. Sometimes the plastic retainer on the push rod gets stripped after years of use and needs to be replaced.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Trim motor installed on SLTX now slipping
    By vwztips in forum Polaris Open Discussion
    Replies: 11
    Last Post: 06-13-2016, 12:20 PM
  2. AFR while motor is under load around 5K
    By stuckmoto in forum 4-Tec Performance
    Replies: 18
    Last Post: 09-11-2013, 07:16 PM
  3. trim motor not working
    By scottr2200 in forum Polaris Open Discussion
    Replies: 8
    Last Post: 07-12-2007, 02:42 PM
  4. Trim Motor Repair
    By beerdart in forum Polaris Open Discussion
    Replies: 9
    Last Post: 04-11-2007, 02:06 PM
  5. trim motor #2...dead!
    By Wolf Child in forum Polaris Open Discussion
    Replies: 7
    Last Post: 09-25-2006, 11:01 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts