08-12-2009, 12:37 PM #1
Question bout RXP-X IC reposition kit
IS the riva Intercooler reposition kit and pipes radically different than the Gen I IC mount and pipes could that be used in an RXP-X (Gen I Bracket and pipes)
08-12-2009, 12:46 PM #2
08-12-2009, 02:20 PM #3
Are you going to use the X intercooler? I just did this to my PX. I cut up an old RVIA intercooler bracket and use part of the PX OEM bracket and then made new pipe/hoses to hook it up. I don't think the old GEN1 pipes will work because of the exit angles on the X intercooler. If you straight out those exits, I guess you could use them. Also, did a rear exit exhaust, too. Trust me, none of this was much fun to do.
08-14-2009, 04:49 AM #4
ok so the gen I mount and pipes are not so useful then is what your saying? I guess what I am trying to decide is if I should keep a gen I mount bracket and pipes in the hopes of using them on a future purchase of an RXP-X.
08-14-2009, 05:44 AM #5
I used the Gen1 stuff in my PX and had to break out the welder to make everything fit. I would NOT recommend this to anyone.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By CKYnick in forum 4-Tec PerformanceReplies: 10Last Post: 04-20-2008, 09:06 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 52Last Post: 04-20-2006, 06:40 PM
By Pale Rider in forum 4-Tec PerformanceReplies: 11Last Post: 11-06-2005, 10:06 AM
By Jarrett in forum 4-Tec PerformanceReplies: 3Last Post: 06-29-2005, 03:14 PM
By joeg in forum 4-Tec PerformanceReplies: 2Last Post: 06-18-2005, 09:55 AM