Results 1 to 3 of 3
  1. #1

    Starter prob fixed...more questions

    93 SL 750 got it running...compressions are in question...mag cylinder 110 psi middle 120 psi n pto 110 psi...did the old oil in the cylinder all the psi's were 150 and higher...im assuming the head gaskets are still good can i get by without tearing it apart n replacing the rings? also my exhaust manifold gasket looks a little beat up...can i get by? does the trim motor only work with the engine running? does my ski have a low oil light? where is it? where can i get cheap gaskets n rings n stuff like that? is there anyway to install the exhaust manifold without the pipe right up against it? it gets in the way big time trying to tighten esp the mag side bolts on the manifold! thanks so much!


  2. #2
    She likes the bike. But the ski gets her wet!!!! xlint89's Avatar
    Join Date
    Oct 2006
    Location
    Cleveland OH
    Posts
    17,330
    +1
    31
    Welcome to the Hulk XLT.

    Compresson is fine. Would be nice if it were higher, but no need to re-ring it yet.

    What do you mean the gasket looks beat up? If it's damaged, replace it.

    Trim only works when engine is running.

    Low oil indicator is on the Multi Function Display

    You can make your own gaskets depending on what you need.

    Many places sell parts, none are cheap though....

  3. #3
    Quote Originally Posted by xlint89 View Post
    Welcome to the Hulk XLT.

    Compresson is fine. Would be nice if it were higher, but no need to re-ring it yet.

    What do you mean the gasket looks beat up? If it's damaged, replace it.

    Trim only works when engine is running.

    Low oil indicator is on the Multi Function Display

    You can make your own gaskets depending on what you need.

    Many places sell parts, none are cheap though....

    thanks so much! just need the exhaust manifold gasket its starting to flake apart pretty bad...i can get one on ebay for 25 shipped...or should i use that copper stuff for high heat? also is there some easier way to bolt n unbolt the manifold to the block that pipe is in the way for those last few bolts so annoying! thanks again!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. That newb with more questions about honing
    By Seanace1 in forum Polaris How To & FAQs
    Replies: 3
    Last Post: 06-20-2009, 03:55 PM
  2. Couple more questions
    By race24x in forum 2-Stroke Performance
    Replies: 1
    Last Post: 06-20-2008, 11:50 AM
  3. More questions on 02 xlt fuel issues
    By coastalfun in forum Yamaha Open Discussion
    Replies: 7
    Last Post: 03-28-2008, 11:07 PM
  4. starter prob on GP1200R...anyone??
    By havoc in forum Yamaha PWC Performance (2-stroke)
    Replies: 22
    Last Post: 04-02-2007, 08:46 PM
  5. A few more questions about Riva's Stage III
    By RXPED in forum 4-Tec Performance
    Replies: 9
    Last Post: 10-09-2006, 07:57 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •