Thread: Pump shoe recess??
08-11-2006, 01:10 PM #1
Pump shoe recess??
What is average recess for the pump shoe in the hull??
I am getting .050 to .030 front to back on waterbox side and
.070 to .060 on other side. This is completly dry and clean with
Went to Yamaha this morning and measured new boat just out of crate
it was .060 all 4 corners.
Just finished reinforcing pump area as per Billy's detalied specs and
went to glue shoe in and found this.
08-11-2006, 01:38 PM #2
Did you put in the PPK ?
08-11-2006, 01:49 PM #3
It was great to meet you last weekend. Thease guys will get an answer for you.
Say hi to Leo.
08-11-2006, 01:56 PM #4
WFO...I put the PPK in and wire whelled everything below the surface
of the shoe. There were some stress cracks around the original nut inserts
and has me thinking it distorted the hull slightly.
Mark it was great to meet all of you and hope to go riding soon!!
08-11-2006, 02:25 PM #5
Dont know what year your boat is. Are you using the new style inserts ?
08-11-2006, 02:34 PM #6
It is an 01, installed the new style inserts when I reinforced the
pump tunnel. There were some minor stress cracks around the original
inserts and wondering if this distorted the hull mounting surface.
08-11-2006, 02:34 PM #7
on my 05 i measured .060ish on the fron and .040 on the rear..... i just pulled it off and will reinstall it this weekend to hopefully get it a little bit better!
08-11-2006, 02:44 PM #8Originally Posted by Duke
08-11-2006, 02:45 PM #9
08-11-2006, 03:07 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Prism in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 07-11-2010, 09:41 PM
By cmherrera in forum Yamaha PWC Performance (2-stroke)Replies: 24Last Post: 12-31-2008, 09:00 PM
By Rendog in forum Sea Doo Open DiscussionReplies: 7Last Post: 07-19-2006, 08:48 AM
By Shibby1485 in forum Sea Doo Open DiscussionReplies: 7Last Post: 07-18-2006, 09:31 PM
By rapidacceleration in forum 4-Tec PerformanceReplies: 4Last Post: 07-04-2006, 10:18 AM