Thread: head milling
08-28-2009, 07:50 AM #1
im thinking about getting my stock head milled plus my exhaust manifold milled,do you guy's think its werth it? ive rejeted the carbs with an R & D f/a plus R & D nozzles 85-88. advice would be great,i got this info on milling these bit from an online seadoo racing manual,with specs.
08-28-2009, 10:02 AM #2
08-28-2009, 10:16 AM #3
08-29-2009, 03:41 AM #4
i sirpose it was a stupid question my next one is,would it be ok to run 95 ron fuel? here in the uk that is standard unleaded and super is 99 ron, or should i use this one?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 2004 xlt1200 in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 07-03-2009, 10:20 AM
By steven1300r in forum Yamaha Open DiscussionReplies: 31Last Post: 12-17-2008, 09:23 PM
By night022 in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 09-18-2008, 07:00 PM
By 1fastrat in forum 2-Stroke PerformanceReplies: 12Last Post: 08-26-2008, 07:10 PM
By PAINKILLER in forum 4-Tec PerformanceReplies: 3Last Post: 02-15-2006, 07:45 AM