Thread: 00 SLX drive coupler
09-09-2009, 05:46 PM #1
00 SLX drive coupler
I noticed when I took my drive shaft out to check for trueness my drive coupler is actually what is out of round. The inside where the shaft slides in is spinning out of round. Is this common or did I do something to cause this. I do alot of very high wave jumping. My motor mounts are still good. Any help would be great.
09-09-2009, 07:51 PM #2
Yes the jumping could have caused this especially if you don't let off on the throttle before coming back in the water. Could just be the rubber dounut needs to be repositioned...which if is the case, just get a new coupler...the dounut is really squeezed in there with a press.
09-09-2009, 07:55 PM #3
Would I be better off to go to the solid coupler like the Pro 1200 if thats even possible.
09-09-2009, 08:29 PM #4
i've done 2 bonded to solid coupler and both had to be realigned to line up the d/s right.i got a practically brandy new one,shoot me a pm
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By tburn in forum Polaris Open DiscussionReplies: 6Last Post: 05-23-2010, 07:13 PM
By koryk in forum Polaris ClassifiedsReplies: 5Last Post: 04-17-2010, 09:48 AM
By bmill in forum Polaris Open DiscussionReplies: 6Last Post: 10-18-2007, 09:39 AM
By SharkCrazy in forum Polaris Open DiscussionReplies: 8Last Post: 06-26-2007, 11:12 PM
By dhoad in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 04-19-2007, 07:43 AM