I fixed my Info Center gauge as seen in my previous thread, but now I have major problems changing what to show on the gauge. Right after I fixed the gauge it was possible to switch between the different modes but sometimes with a little delay and I had to push the mode button several times.

Since then I have used the ski quite hard jumping waves and now I find it impossible to change what to show, I only get the clock which is quite uninteresting. The mode button works, I measured it down by the MPEM connector.

Could I be looking at a faulty MPEM here? The VTS fuse in the MPEM burns as soon as I replace it, but that shouldn't have anything to do with the gauge right?

Any input is appreciated.