Results 1 to 6 of 6

Thread: trouble code ?

  1. #1

    Join Date
    Jun 2005
    Location
    near detroit michigan
    Posts
    299

    trouble code ?

    today my check engine light came on a few times and would go off
    after approx 3 starts. to code is 0520 (oil pressure sensor functonality fault) has any bodys had this and what repairs were done(my oil was approx 1/4 qt low just under the bottom bend. the code dosnt set /no light while driving but if i shut it off and restart it comes on.any ideas,dose anybody know where the oil pressure switch/sensor is?


  2. #2

    Join Date
    Jun 2005
    Location
    miami,fl
    Posts
    54
    put oil level between both bends and see what it does you are low on oil

  3. #3

    Join Date
    Jun 2005
    Location
    near detroit michigan
    Posts
    299
    I arledy toped it off and i will test tuseday after work hope that is it.

  4. #4
    if you have too much oil, it can throw that code, but it also could be a faulty pressure sending unit.

  5. #5
    Enufpwr's Avatar
    Join Date
    May 2005
    Location
    Lake St. Clair, Michigan
    Posts
    446
    Kevin,

    says... possible causes
    Engine leak, oil pump failure, damaged sensor, damaged circuit wires, damaged connector, or damaged ECM pins

    Trouble codes:
    http://www.sea-doo.net/Specification...stic-Codes.pdf


    Sent you a IM with more details on where to find the sensor.

  6. #6

    Join Date
    Jun 2005
    Location
    near detroit michigan
    Posts
    299
    thank daren

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Tip: Trouble codes for 4 Tec's
    By Green Hulk in forum Sea Doo How To & FAQs
    Replies: 72
    Last Post: 06-15-2013, 09:35 AM
  2. Please Help...Trouble Code!
    By RustySeaRustyDoo in forum 4-Tec Performance
    Replies: 34
    Last Post: 06-04-2009, 02:36 AM
  3. TROUBLE CODE p 0546 ???
    By CRAZEDRXP in forum 4-Tec Performance
    Replies: 9
    Last Post: 06-20-2007, 06:43 PM
  4. Virage 800di - Get Trouble codes? Help IDing part
    By cgustafs in forum Polaris Open Discussion
    Replies: 2
    Last Post: 06-11-2007, 09:09 PM
  5. HELP: Trouble Code 0326 Knock Sensor out of Range
    By majundecid in forum 4-Tec Performance
    Replies: 5
    Last Post: 05-23-2007, 08:13 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •