08-19-2006, 12:58 PM #1
Stainless Steel Wear Rings now available in online store
Don't forget your coupon code for a discount
08-19-2006, 03:52 PM #2
Can these be replaced like the original ones? The freezer trick!
08-19-2006, 05:48 PM #3
No, you use a wood block across the top of it and tap it in with a hammer.
08-19-2006, 07:36 PM #4
Thats tight just the way I like it
08-19-2006, 08:21 PM #5
Jerry, will u be selling the interchangable venturi rings also?
08-19-2006, 08:23 PM #6
08-19-2006, 08:33 PM #7
no , just the extra rings for the venturi.
08-19-2006, 08:39 PM #8
Unfortunately no. Give Glen at Skat a call and he'll hook you up.
08-19-2006, 09:11 PM #9
Do you think its safe to use this without stablizing the drive line(i.e. front engine mount or triple bearings) Im hoping it would be.
08-19-2006, 09:21 PM #10
I used the SS wear ring for about 30 hours with no issues. Later i had the tripple bearing pump mod done.
I think if you stabilize the driveline by upgrading to the RR mount then you would probably never have to do the tripple bearing mod.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By chewie81 in forum 4-Tec PerformanceReplies: 8Last Post: 07-20-2008, 03:12 AM
By 2stroke_bluesmoke in forum 4-Tec PerformanceReplies: 0Last Post: 07-19-2007, 08:53 PM
By The Bandit in forum 4-Tec PerformanceReplies: 11Last Post: 02-22-2007, 08:01 PM
By Red Devil in forum 4-Tec PerformanceReplies: 27Last Post: 06-28-2005, 07:07 PM
By shortee in forum 4-Tec PerformanceReplies: 12Last Post: 06-18-2005, 09:36 PM