Thread: RXT-X Hull ventilation question
09-25-2009, 04:11 AM #1
RXT-X Hull ventilation question
I was hoping to improve my hull ventilation, by opening some holes on the back of the rear seat, under the grab handle, somewhat like Danny did on his direct air intake mod, but i do a lot of agressive offshore riding, and i do flip the RXT-X upside down a couple of times...
So, will go with the kanaflex setup for safety issues, but i still want some fresh air in the hull, that's why i was thinking of drilling the back of the rear seat. Won't that be an issue if (or when) i flip the TX upside down again? I can imagine that water will go in very very fast when that happens!
09-25-2009, 08:45 AM #2
Here's my thought: Just add some front oem parts opposite the reverse handle.......the vent will be covered in the same manner as the original front vent; the seat.
10-08-2009, 04:46 AM #3
Is this a good spot to drill a couple of holes on the hull? Under the black plastic grill?
10-08-2009, 04:53 AM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By boostaholic in forum Conversion PWC Performance SkisReplies: 11Last Post: 11-22-2007, 08:31 PM
By Green Hulk in forum Kawasaki PWC Performance (4-stroke)Replies: 0Last Post: 10-02-2007, 01:09 PM
By GODOSIDIS in forum Kawasaki PWC Performance (4-stroke)Replies: 26Last Post: 09-22-2007, 05:02 AM
By TCR in forum Kawasaki Open DiscussionReplies: 13Last Post: 09-21-2007, 01:17 AM
By Shibby1485 in forum 4-Tec PerformanceReplies: 1Last Post: 02-25-2007, 06:56 PM