Results 1 to 3 of 3

Thread: need help

  1. #1

    need help

    ok guys need to replace my duct impellar housings. i have not done this yet, so i need some of your good advice. my 98 yamaha 760 shaft length is diffrent about two inches shorter than the used assembly i just purchased (98 1200). so in order to switch shafts to make this work, I do what? are these compressed in? the 760 sems to have a place for wrench to hold while unscrewing shaft? 1200 does not any help would be appreciated............. 760 is a 65r10 stamped on it


  2. #2
    Mpeavler's Avatar
    Join Date
    Dec 2005
    Location
    Anderson, Indiana
    Posts
    5,155
    +1
    170
    You will need to remove your old Shaft and have the bearings and seals pressed into the new one. I do recommend you replace the bearings and seals..while your there.

    M

  3. #3
    thanks m for the reply i will work on it this weekend

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. new 05 RXT NEED HELP
    By RXPNJ in forum 4-Tec Performance
    Replies: 12
    Last Post: 07-03-2009, 12:16 PM
  2. NEED HELP URGENT(HULK) RXP DOWN
    By macattack in forum 4-Tec Performance
    Replies: 28
    Last Post: 11-22-2005, 02:39 PM
  3. My 2 RXP's need HELP!
    By Tube Master in forum 4-Tec Performance
    Replies: 21
    Last Post: 07-19-2005, 09:44 PM
  4. I need help remove stock intercooler
    By orc in forum 4-Tec Performance
    Replies: 3
    Last Post: 05-13-2005, 04:08 PM
  5. NEED HELP!!!!!
    By MartyRXP in forum 4-Tec Performance
    Replies: 11
    Last Post: 05-10-2005, 08:15 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •