Thread: Extended Battery cables
10-02-2009, 01:43 PM #1
Extended Battery cables/holder & J-Pipe Clamp
Trying to get the garage cleaned up here and maybe help someone out.
If by chance you are going to mount the battery in the back this is perfect. Positive cable to go from the very front to the rear (behind waterbox) and then Negative cable to go from the battery up to the block. If anything they are 6" to 12" to long. It is 4 AWG tinned marine cable.
Battery holder for PC925 Battery. Pretty sure it will also hold the regular 4-Tec one since I am using the PC925 in the RXP one.
The back corner was cut so it would fit better in back of the MC-1 Waterbox. Other than that its needs a good cleaning... I had it mounted between the trim tab brackets.
J-Pipe Clamp for Ex Manifold
10-13-2009, 09:53 AM #2
10-22-2009, 04:51 PM #3
Still have the cables and the PC925 Battery box if anyone is interested.
10-23-2009, 05:18 PM #4
Thanks again. It's going on the MSX conversion
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By L Carlson in forum Yamaha Open DiscussionReplies: 9Last Post: 11-24-2007, 08:19 PM
By wood1067 in forum Polaris Open DiscussionReplies: 9Last Post: 08-24-2007, 08:25 AM
By GP12R in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 08-11-2007, 05:39 PM
By WATER WOODY in forum Yamaha PWC Performance (2-stroke)Replies: 21Last Post: 08-08-2007, 08:24 AM
By seadoo951 in forum Sea Doo Open DiscussionReplies: 5Last Post: 04-15-2007, 05:11 PM