Thread: servo problem
10-07-2009, 07:17 PM #1
ski is a 01 xlt 1200
pv servo is cycling constantly why?
not the cable adjustment still cycles w/o cables hooked up
any help id like to get this guy back on the water before it gets cold
10-07-2009, 08:42 PM #2
Pull the PV motor and crack the case. You will likely find the circuit board burned where the 12v lead attaches to the board - which is caused by water leaking into the casing. Get a new motor, seal it with silicone, and you're done.
10-07-2009, 09:29 PM #3
1st servo was doing this then stopped
then stopped all togather
2nd servo cycles as soon as plug up the connector ,stops for few seconds and then cycles again ....continuously
3rd servo has its chit togather and is working good,now
i really hope #3 keeps it togather
i opened #2 up before you posted everything looked good?
oh well im goona eat some oreos and watch ufc
10-08-2009, 09:36 AM #4
Did you seal up the third one? If not, expect this to happen again.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By HallPass in forum Yamaha Open DiscussionReplies: 5Last Post: 09-20-2007, 03:13 PM
By airbornexp in forum 2-Stroke PerformanceReplies: 8Last Post: 08-26-2007, 10:48 PM
By Shibby1485 in forum Yamaha Open DiscussionReplies: 1Last Post: 08-16-2007, 08:55 PM
By arod25 in forum Sea Doo Sport BoatsReplies: 7Last Post: 06-28-2007, 07:23 PM
By spud in forum Yamaha PWC Performance (2-stroke)Replies: 13Last Post: 04-23-2006, 11:51 PM