10-14-2009, 02:12 PM #1
Need help with slip on a 2Rude Sc.
I need some input on the "slip" for a 2Rude Sc. Please! Need to know the magic number. I would appreciate all the input send.
10-14-2009, 02:38 PM #2
I set mine up for 16-18 ft/lb using the McMasters spring tension washers ( they hold better than stock). You will need a torque wrench that goes this high.
10-14-2009, 02:45 PM #3
10-14-2009, 03:01 PM #4
What's it slipping at now, Doel??
10-14-2009, 03:04 PM #5
10-14-2009, 03:09 PM #6
10-14-2009, 03:31 PM #7
10-14-2009, 04:53 PM #8
Rule of thumb
The rule of thumb is one lb of slip per lb of boost.
10-14-2009, 09:28 PM #9
180in. lbs. Is were you want to start. I just did 2 of them and Nils said 180 is good. I only needed 1 Mc.. Washer for each SCer as they hold that well IMO.
10-14-2009, 09:37 PM #10
16lbs will hold for a stock ECU and 2Rude. Thought you had a 3Rude.
Really like the SS McMaster spring washers with the heat generated by these large displacement chargers.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By DIGGS in forum 4-Tec PerformanceReplies: 3Last Post: 08-31-2007, 09:47 AM
By Snoman in forum 4-Tec PerformanceReplies: 11Last Post: 06-28-2007, 10:23 PM
By Top banana in forum 4-Tec PerformanceReplies: 11Last Post: 08-09-2006, 01:24 PM
By Big Red Monster in forum 4-Tec PerformanceReplies: 11Last Post: 07-15-2006, 10:14 AM
By Tube Master in forum 4-Tec PerformanceReplies: 4Last Post: 05-31-2005, 11:02 AM