Results 1 to 5 of 5
  1. #1
    RXPDAVID's Avatar
    Join Date
    Apr 2005
    Location
    West Tennessee
    Posts
    403

    Riva thru hull exhaust---2 7/8 Hole saw ---- Loctite 5910

    Did anyone have a hard time finding a 2 7/8 hole saw? Also can't locate Loctite 5910 Sealant around here for the supercharger. What did you use or where did you find it?


  2. #2

    Join Date
    Jul 2005
    Location
    Coral Springs
    Posts
    84
    good luck finding the 5910. grainger and mcs dont even carry it.

    When i looked it up at permatex/loctite the spec said non corrosive. if that helps.

    also saw 5910 for sale at parker yamaha for $20.

  3. #3
    Site Admin Green Hulk's Avatar
    Join Date
    Apr 2005
    Location
    Morgan City, LA
    Posts
    34,995
    +1
    1,900
    Griff, just use some Permatex Ultra Black silicone in lieu of the 5910

  4. #4
    Moderator Franko's Avatar
    Join Date
    Apr 2005
    Location
    Dallas, Texas
    Posts
    3,829
    +1
    2
    I used a 2 3/4 hole saw bit and used 60 grit sand paper to make the hole 2 7/8. For the SC housing, I used Ultra Black.

  5. #5

    Join Date
    Apr 2005
    Location
    Elysian Fields,Tx
    Posts
    358
    For anyone looking for Loctite supplies. This place carries it all. The Loctite 5910 only came in a 300 Ml Cartridge. Enough to do about a thousand super chargers.But Jerry and Franko are right, the Ultra Black sealant they mentioned works fine.

    Global Stores Group
    26701 Winged Elm Drive
    Wesley Chapel,Fl 33543

    WWW.globalstoresgroup.cyberhost.com
    800-353-8969

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Riva Thru Hull Exhaust Install - help
    By wolf513 in forum 4-Tec Performance
    Replies: 26
    Last Post: 08-29-2008, 09:32 PM
  2. Big news on the Riva Thru Hull Exhausts
    By Green Hulk in forum 4-Tec Performance
    Replies: 10
    Last Post: 09-27-2006, 03:05 AM
  3. PPG resonated powerpipe or Riva thru-hull exhaust???
    By GPR/STX-15F/RXT in forum 4-Tec Performance
    Replies: 15
    Last Post: 02-27-2006, 07:51 AM
  4. Riva thru hull exhaust / PPG power pipe
    By RXPDAVID in forum 4-Tec Performance
    Replies: 5
    Last Post: 07-10-2005, 11:19 AM
  5. Riva Thru Hull Exhaust ** VIDEO ATTACHED**
    By Green Hulk in forum 4-Tec Performance
    Replies: 46
    Last Post: 06-30-2005, 10:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •