Results 1 to 4 of 4
  1. #1
    Chrisrokc's Avatar
    Join Date
    Apr 2006
    Location
    Oklahoma City, OK
    Posts
    3,667

    Removing Bildge Tube In Pump Nozzle

    What should I know about this? Once I remove it and jb weld the hole shut what do I do with the tube for the bildge? Any info will be helpfull!


  2. #2
    I just left it hooked up with a small hose clamp so it would look normal. No problems at all. Depending on how you eliminated it. I used a die grinder on the inside of the nozzle. If you removed the entire piece then I would clamp a vacume plug at the hull.
    Last edited by porksword; 08-25-2006 at 05:20 PM.

  3. #3
    ABBOTT's Avatar
    Join Date
    Jul 2005
    Location
    Birmingham, AL / Lay Lake
    Posts
    3,736
    +1
    96
    Quote Originally Posted by porksword
    I just left it hooked up with a small hose clamp so it would look normal. No problems at all. Depending on how you eliminated it. I used a die grinder on the inside of the nozzle. If you removed the entire piece then I would clamp a vacume plug at the hull.

    That is a good idea ^^ , or you can just rip the whole thing out. Some say that it helps to leave this in "as stock" because it helps pressurize the pump and airiates the hull too. Just my 2 cents.

  4. #4
    Chrisrokc's Avatar
    Join Date
    Apr 2006
    Location
    Oklahoma City, OK
    Posts
    3,667
    Quote Originally Posted by ABBOTT
    That is a good idea ^^ , or you can just rip the whole thing out. Some say that it helps to leave this in "as stock" because it helps pressurize the pump and airiates the hull too. Just my 2 cents.
    Hmm, so it might be better to leave as is.

    What do you guys have?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 0
    Last Post: 08-11-2010, 05:06 PM
  2. Installing Siphon Tube in nozzle
    By use2vtec in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 08-04-2010, 10:54 AM
  3. Grooves in Pump Support Bracket
    By Red Devil in forum Sea Doo Open Discussion
    Replies: 3
    Last Post: 06-06-2006, 08:50 PM
  4. R&D pump nozzle kit
    By Green Hornet in forum 4-Tec Performance
    Replies: 25
    Last Post: 12-30-2005, 06:38 PM
  5. skat trak pump nozzle
    By rancarts in forum 4-Tec Performance
    Replies: 14
    Last Post: 12-28-2005, 05:50 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •