Thread: Thru Hull Exhaust RXP
11-06-2009, 12:15 PM #1
Thru Hull Exhaust RXP
i got a problem with the Riva outlet template,
the diameter from the hole on the paper is smaller then the exhaust tip!
is that normal?
i expose here a picture,
can someone tell me how long is the line 1 and 2 on your RXP... (in mm please, when its possible)
11-06-2009, 12:28 PM #2
The template is smaller... but the center point is correct
Just took a quick measurement of mine... 6" both dimensions. (152.4mm)
11-06-2009, 12:32 PM #3
11-06-2009, 12:44 PM #4
Yep. Looks good. I had a hard time getting mine right too but for different reasons.
I had to call riva when installing my tip with the Riva waterbox. They said that the template that came with the waterbox was based off of the riva free flow exhaust and not the waterbox.. they had no explanation why they would include a tempate for something that it wasnt designed for. They said it was 'close enough'.
11-06-2009, 12:53 PM #5
11-06-2009, 12:58 PM #6
at my 04 RXP is the location where i must drill the hole not even, so the rubber gasket can not sealing 100%!
how it was at your RXP´s!
"therefore i think i have the wrong place to drill!"
11-06-2009, 12:58 PM #7
Careful with the holesaw too. Mine kicked like a bastard.
11-06-2009, 01:02 PM #8
11-06-2009, 01:03 PM #9
11-06-2009, 01:04 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By JordanHaye in forum 4-Tec PerformanceReplies: 2Last Post: 06-06-2007, 07:45 PM
By seadoo951 in forum 4-Tec PerformanceReplies: 16Last Post: 04-13-2007, 04:23 PM
By LAB69 in forum 4-Tec PerformanceReplies: 3Last Post: 02-01-2007, 07:59 PM
By GhostRxp in forum 4-Tec PerformanceReplies: 2Last Post: 06-07-2006, 05:57 PM
By excess in forum 4-Tec PerformanceReplies: 3Last Post: 06-01-2006, 07:44 PM