Results 1 to 7 of 7
  1. #1

    Join Date
    Aug 2009
    Location
    CA
    Posts
    237

    PTO installation?

    Need to transfer parts over to my 05 RXP from the old engine to my rebuilt engine. The PTO, flywheel, stator, bendix.... . Any tips or should it be pretty straight forward. I just purchased the updated flywheel bolts also. Thanks


  2. #2
    it is not that difficult. i wouldn't do it without a service manual though. good luck.

  3. #3

    Join Date
    Aug 2009
    Location
    CA
    Posts
    237
    Can I just use permatex high tack sealant on the PTO gasket? Also should I could any parts with oil before I bolt the cover back on?

  4. #4
    formerly Gold06RXP Turbo Nick's Avatar
    Join Date
    May 2007
    Location
    Dayton, OH
    Posts
    2,095
    +1
    97
    You have to buy the PTO cover gasket. RTV will not work

  5. #5

    Join Date
    Aug 2009
    Location
    CA
    Posts
    237
    I meant on the gasket, I have the gasket also.


    Quote Originally Posted by GOLD06RXP View Post
    You have to buy the PTO cover gasket. RTV will not work

  6. #6
    formerly Gold06RXP Turbo Nick's Avatar
    Join Date
    May 2007
    Location
    Dayton, OH
    Posts
    2,095
    +1
    97
    No, dont use any RTV. Just make sure the mating surfaces are clean

  7. #7

    Join Date
    Aug 2009
    Location
    CA
    Posts
    237
    I am not talking about RTV, I am talking about the high tack sealer to hold the gasket in place. I am pretty sure that several people on this board use the permatex or the loctite version of the high tach sealer also.



    Quote Originally Posted by GOLD06RXP View Post
    No, dont use any RTV. Just make sure the mating surfaces are clean

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to re-install PTO seal?
    By GTLaser in forum Sea Doo Open Discussion
    Replies: 5
    Last Post: 05-02-2011, 05:05 PM
  2. PTO Water / Oil Pump Shaft Installation Question
    By Craigo in forum 4-Tec Performance
    Replies: 5
    Last Post: 12-14-2010, 01:49 AM
  3. Re-Installing Floating Bearing PTO- 04 RXP
    By jekvall in forum 4-Tec Performance
    Replies: 3
    Last Post: 04-16-2010, 09:40 AM
  4. 1100 Crankshaft (PTO SIDE) crank bearing installation
    By bnovak in forum Yamaha Old School Skis
    Replies: 12
    Last Post: 10-22-2007, 06:38 PM
  5. 1100 Crankshaft (PTO SIDE) crank bearing installation
    By bnovak in forum Yamaha PWC Performance (2-stroke)
    Replies: 4
    Last Post: 10-07-2007, 08:42 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •