Thread: Wired Remote Routing Help?
11-15-2009, 10:24 PM #1
Wired Remote Routing Help?
I have learned a lot since joining the forums and would like to know how you ran your wired remotes to the driver's console. I have a 1998 Challenger 1800 and would like to install the compatible wired remote from the radio in the passenger side glove box to the driver side. Do I need to run it all the way through the engine bay and backup the side. Can it be run through the ski locker area?
What have you guys done? Thanks!
11-16-2009, 04:57 PM #2
Alright guys, got it done. It was very simple after all. For those of you that may be interested in doing it yourself;
-ran a snake from the locker and it went right up into the passenger side console.
-snaked the remote cable into the locker
-ran the snake from the locker to the drivers console
-attached a smaller wire to the end of the snake and pulled that into the locker
-attached the smaller pull wire to the remote cable
-pulled the remote cable into the drivers console using the smaller pull wire
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By seadoobutch787 in forum 2-Stroke PerformanceReplies: 1Last Post: 12-05-2007, 12:03 PM
By VegasRatt in forum Polaris PWC PerformanceReplies: 6Last Post: 10-05-2006, 09:16 PM
By RXPNJ in forum Sea Doo Open DiscussionReplies: 4Last Post: 07-03-2006, 03:33 PM
By GPR/STX-15F/RXT in forum 4-Tec PerformanceReplies: 12Last Post: 04-28-2006, 09:42 PM
By CanadianGPR in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 04-01-2006, 11:47 AM