Results 1 to 3 of 3
  1. #1
    jmatak9's Avatar
    Join Date
    Jul 2009
    Location
    St. Cloud, Fl
    Posts
    435

    bearing (pulley assembly)

    Has anyone had to change out bearings in the pulley after water submerging up to the drive shaft? or did youre ski run fine? Just wondering if should do mine or not. I have 40 hrs. on the ski and this happened just once to me here recently.


  2. #2
    If it is stock then leave it alone. Chrager has sealed bearings. That and you cant change the bearing in the stock pulley. It is crimped into place.

  3. #3
    jmatak9's Avatar
    Join Date
    Jul 2009
    Location
    St. Cloud, Fl
    Posts
    435
    Thanks Skip

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. WTB Ultra 250/260 supercharger pulley assembly
    By ctct2118 in forum Kawasaki Classifieds
    Replies: 1
    Last Post: 07-05-2016, 09:52 PM
  2. Differences between Polaris through-hull bearing assemblies
    By K447 in forum Polaris Open Discussion
    Replies: 20
    Last Post: 01-19-2015, 12:31 PM
  3. Replies: 3
    Last Post: 07-28-2011, 09:13 PM
  4. Bad bearing, damaged impeller assembly (pictures)
    By richsrq in forum Polaris Open Discussion
    Replies: 26
    Last Post: 10-04-2008, 07:24 AM
  5. Bearing assembly MSX140/150/110
    By xsantia in forum Polaris How To & FAQs
    Replies: 5
    Last Post: 05-05-2007, 11:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •