Results 1 to 3 of 3
  1. #1
    If i knew,...I wouldn't ask sea-one's Avatar
    Join Date
    Aug 2009

    RXP bilge pump install question

    I wanted to install a float switch and wire it HOT to the battery so that in case something goes wrong or while its tied up at our dock it would pump,and i wanted to put the thru hull fitting somewhere where i could see it from the house deck and get to it quickly....what do you think


  2. #2
    JT jpt7779's Avatar
    Join Date
    Jul 2008
    Pittsburg, Texas Lake Bob Sandlin
    I'm not at a computer so can't paste link but, go to how to section, read my how to install bilge pump, groco strainer, 4" kanaflex thread

    Everything you want to know is there. See post #22 for latest document version. Near end of thread is Rxp - px info.

    Good luck

  3. #3
    Nothin' better than Doo'in it! BigDaddyRXP's Avatar
    Join Date
    Aug 2007
    Tampa Bay, FL
    I think that sounds good... Doo it

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. RXP Bilge Pump install
    By Vern in forum 4-Tec Performance
    Replies: 14
    Last Post: 08-27-2014, 10:04 AM
  2. How-To: Bilge Pump Installation in an RXP-X (Lots of Photos)
    By RobWCanada in forum Sea Doo How To & FAQs
    Replies: 46
    Last Post: 08-11-2013, 07:37 AM
  3. RXP bilge pump install question
    By sea-one in forum Open Discussion
    Replies: 0
    Last Post: 11-18-2009, 07:14 PM
  4. RXP bilge pump install... Transom outlet ???'s
    By jtskier11 in forum 4-Tec Performance
    Replies: 25
    Last Post: 07-10-2009, 12:33 PM
  5. RXP bilge pump install
    By The Bandit in forum Sea Doo Open Discussion
    Replies: 73
    Last Post: 08-07-2007, 06:41 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts