Thread: wear ring question???
11-23-2009, 06:05 AM #1
wear ring question???
its been a really long while since posting here.since the last time i was on here i have sunk my ski, added pump extension, exhaust manifold extender and a c-kit.
anyways i remember reading somewhere on here that some of u guys were using some product to smooth out or repair the oem wear ring. i have searched with no luck finding the thread. any help would be great.
11-23-2009, 07:35 AM #2
People were using epoxy filler. Smoothing over the worn areas and then back the boat in to the water and start it up and it takes all the high spots off it.
11-23-2009, 07:45 AM #3
11-23-2009, 03:21 PM #4
just flip it over. or get a new one. too much to do for something that is cheap in the parts world.
11-23-2009, 04:26 PM #5
Yep, you can flip over once if you have not already bro.
11-23-2009, 09:40 PM #6
The Pump in the freezer works great too. Slides right out, slides right in......the wear ring.....
11-23-2009, 09:57 PM #7
If your in a bind and need it asap fill it but if not i wouldnt wast the time and just buy a new one.
11-23-2009, 10:08 PM #8
11-27-2009, 11:40 AM #9
- Join Date
- Jul 2007
- PDX - Oregon
11-27-2009, 12:01 PM #10
We just use basic plastic epoxy here..works great..Just make sure you clean and scuff youe surface with some sand paper before adding the epoxy...
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By lee in forum 4-Tec PerformanceReplies: 2Last Post: 10-08-2007, 10:40 PM
By speedy in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 04-27-2007, 08:51 PM
By qbzonk in forum Yamaha Open DiscussionReplies: 2Last Post: 04-24-2007, 07:11 AM
By NJ-Ski in forum Sea Doo Open DiscussionReplies: 8Last Post: 07-16-2006, 12:47 PM
By GeoRXT in forum 4-Tec PerformanceReplies: 14Last Post: 04-18-2006, 11:46 AM