12-23-2009, 01:21 PM #1
WTB or Barrow Sea Doo Driveshaft Tool
Does anyone have a Sea Doo Driveshaft Tool, that would like to sell it??? Or does anyone would like to rent, me the Sea Doo Driveshaft Tool??? I would only need it for a few days, I will pay for shipping both ways and pay for rental...
Thanks ahead of time..
12-24-2009, 09:07 AM #2
- Join Date
- May 2005
You really don't need it. Many have pulled back the collar without one - I place a block of wood under the drive shaft and use two screw drivers to pull it back and have someone else remove the c clip. Leave the pump on or the shaft will move - I made a simple plate that pushes the shaft in a little instead of using the pump. Add a little lube
good luck and happy holidays
12-24-2009, 09:55 AM #3
12-24-2009, 11:12 AM #4
Above is a thread with some how-to info. I just did mine about 2 weeks ago. My floating ring was stuck and I had to muscle it some to get it off there. Used some lube to get it moving after 5 years!
12-24-2009, 11:38 AM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum 4-Tec PerformanceReplies: 16Last Post: 10-18-2007, 08:32 AM
By Metal4130 in forum 2-Stroke PerformanceReplies: 0Last Post: 07-08-2007, 12:23 AM
By BMW550I in forum Kawasaki PWC Performance (4-stroke)Replies: 159Last Post: 06-18-2007, 09:52 PM
By rapidacceleration in forum 4-Tec PerformanceReplies: 3Last Post: 04-25-2007, 09:55 PM
By Muddy River in forum Sea Doo Open DiscussionReplies: 10Last Post: 01-16-2007, 11:02 PM