Results 1 to 3 of 3
  1. #1

    Join Date
    Jul 2005
    Location
    SE Texas
    Posts
    396
    +1
    3

    Wear Ring Wearing

    Changed the wear rings--
    wear "lines" are obvious-circular rings corresponding to the blades--

    But-- both Doos had similar gouges or "chunks"-- places that had holes in them.

    I was going to just reverse them, but these gouges crossed well into the clear areas on both.

    Is that normal ? I assume the gouges were caused by injesting somthing.


  2. #2
    Its normal if youve sucked something up. If you do not remember sucking something up then it could of just been something in the lake that you didnt see.

  3. #3
    Focker Foggy's Avatar
    Join Date
    Oct 2007
    Location
    Olathe KS
    Posts
    672
    Very Normal.
    Just need to buy new wear ring...
    After all, they are called a "wear" ring

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. TIP - Bar Extensions and Wear Ring Info
    By MikeTrin in forum Sea Doo How To & FAQs
    Replies: 7
    Last Post: 06-19-2007, 03:05 PM
  2. stainless steel wear ring
    By shortee in forum 4-Tec Performance
    Replies: 12
    Last Post: 06-18-2005, 09:36 PM
  3. wear ring damage
    By INDY27 in forum 4-Tec Performance
    Replies: 18
    Last Post: 05-25-2005, 08:41 PM
  4. wear ring removal
    By watermedic in forum Sea Doo Open Discussion
    Replies: 6
    Last Post: 05-18-2005, 09:12 AM
  5. wear ring
    By nitro rxp in forum 4-Tec Performance
    Replies: 16
    Last Post: 05-12-2005, 05:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •