Thread: JD1 Open loop kit
12-31-2009, 08:44 AM #1
JD1 Open loop kit
For sale is the JD1 open loop kit. Used for only about 20 hours. Included is the block off plate, o-ring, reducers (1 for head - includes hose so you dont have to cut yours and 2 for oil cooler), and zink anode. The big reducer was drilled and tapped for an engine temp guage if you would like to add one otherwaise it can be covered with the hose.
$145 shipped and no additional PayPal fees will be added.
International shipping is available for additional charge.
Last edited by Gus13letter; 01-07-2010 at 05:08 PM.
01-03-2010, 08:43 AM #2
01-05-2010, 01:13 PM #3
01-05-2010, 02:01 PM #4
Great price Gus. I'm suprised you still have this.
01-07-2010, 06:47 AM #5
01-07-2010, 07:48 AM #6
Are you going back to stock setup Gus or are you going the Heat exchanger route, curious.
01-07-2010, 08:48 AM #7
01-07-2010, 09:09 AM #8
01-07-2010, 09:23 AM #9
So, no I was accurate to say that I hate the closed loop BS, it sucks and is inefficient.
01-07-2010, 10:15 AM #10
just install what you have. you are overthinking things again. ran les cooke system which is no different than jd's infact jd's has a couple more features. it works just fine without the thermo. too many opinions here. keep the oil hot and you are done.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By allairch in forum 4-Tec PerformanceReplies: 3Last Post: 10-09-2007, 09:57 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 65Last Post: 04-30-2007, 02:24 AM
By beachboy66 in forum 4-Tec PerformanceReplies: 3Last Post: 04-16-2007, 01:04 AM
By Lvnspeed in forum 4-Tec PerformanceReplies: 4Last Post: 01-25-2007, 01:42 PM