01-15-2010, 06:07 PM #1
switching from X Cooler to XS Cooler question.
Over the winter I swapped out components and want to know if I need to drill and tap a bleed line and If I need to use the same bleed line that was in place from the factory X Intercooler?
What method do I use to drill and tap the XS and what parts do I need?
Thanks in advance.
01-15-2010, 06:11 PM #2
Yes, Drill and tap it. It will let all the trapped air out and allow for more water to enter the cooler to let it do its job better. I am not at home to tell you what tap to use, but someone on here will know and post asap.
01-15-2010, 07:26 PM #3
1/8" pipe tap up in the corner of the highest part of your intercooler with a 5/16" or 1/4" hose barb...
Austin you should know the specs on this you told me how to do it!!LOL
01-15-2010, 08:49 PM #4
01-15-2010, 09:54 PM #5
More specs and instructions or a thread please
01-15-2010, 10:08 PM #6
01-16-2010, 12:48 PM #7
01-16-2010, 04:25 PM #8
A few reasons.
1. I plan on going open loop at some point and I do not want a swollen leaky IC (several reports)
2. I like the side mounting points.
3. It looks better and I have mine polished MIRROR shiny
4. It seems to be a better IC for recreational riding (boost etc)
01-16-2010, 04:34 PM #9
- Join Date
- Jul 2005
- Lake Dunlap, Texas
Four great reasons--especially number 4.
01-17-2010, 09:35 AM #10
i think the core from the SEADOO-X cooler is much better then the XS...
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By BertInTexas in forum Sea Doo Open DiscussionReplies: 2Last Post: 11-21-2008, 11:03 AM
By DIGGS in forum 4-Tec PerformanceReplies: 6Last Post: 09-05-2007, 03:09 PM
By nofd843 in forum Sea Doo Sport BoatsReplies: 4Last Post: 07-19-2007, 08:00 AM
By 05gtxsc in forum Sea Doo Open DiscussionReplies: 10Last Post: 04-23-2007, 09:51 PM
By Angelse68cal in forum 4-Tec PerformanceReplies: 17Last Post: 09-14-2005, 08:10 PM