Thread: Will this work on my PRO 1200
01-20-2010, 05:17 PM #1
Will this work on my PRO 1200
I am looking for a solid coupler for my pro 1200 and found this on ebay. Will this work? It came off of a 96 ski. Thanks
01-20-2010, 05:22 PM #2
01-20-2010, 05:33 PM #3
I went to put it in but it is about inch or so longer so it hits the hull coupler. I have a 96 ski that needs one so I am going to use it to replace that one. The coupler you sent is in perfect condition and looks next to new. Thanks
01-20-2010, 06:11 PM #4
01-20-2010, 11:35 PM #5
- Join Date
- Oct 2006
- Cleveland OH
That should work, but it's missing the rubber seal. Any grease will fly out the back of the coupler without it.
If the coupler is hitting the thru hull bearing, you can cut/shorten the rubber hose that attaches the thru hull bearing to the hull.
01-20-2010, 11:40 PM #6
that one will work,and yes the end seal is gone,do you have the end bumpers for the driveshaft??
01-21-2010, 04:08 AM #7
The end bumper that came off of the coupler side was disinagrated, I will make sure I find a new seal and bumper for that side.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By axgrider73 in forum Polaris Open DiscussionReplies: 9Last Post: 07-24-2007, 07:12 PM
By dav_dman in forum Yamaha Old School SkisReplies: 1Last Post: 07-08-2007, 04:07 PM
By allairch in forum Polaris PWC PerformanceReplies: 4Last Post: 06-19-2007, 11:37 AM
By Rodneyae in forum Polaris Open DiscussionReplies: 25Last Post: 05-16-2007, 07:48 PM
By J-ME in forum Polaris Open DiscussionReplies: 9Last Post: 12-02-2006, 08:05 PM