01-22-2010, 06:59 PM #1
Anyone got one laying around? I've broke mine trying to get this dam prop off the blaster pump. I nee the WR004 one
01-22-2010, 07:02 PM #2
01-22-2010, 07:13 PM #3
No it's the prop tool itself....I've broken 3 of these beaches trying to get the blaster prop off doing the "jump" method. I'm done buying tools...going to take it and put the dam thing in a vise and use a breaker bar...I'm tired of buying tools.
01-22-2010, 07:19 PM #4
Solas prop tool ! I had one I can look tommorow.If I can find it its yours I have no use for it it wont fit over my d,shaft.
01-22-2010, 07:23 PM #5
if its the spline tool... get an old intermediate shaft and weld it on heavy , approx 2/3 of the way on the inside of a 3ft steel channel ( i use recycled bed rail channel) the o/e splines are much harder than the tools are and with the channel you have a really big lever or solid base to stand on!
.. if the prop tool a little propane heat goes a long way, along with teflon thread dope
01-22-2010, 07:46 PM #6
Yeah just the tool....I think we break them because I don't have a vise "i know I know"...so we have to do the jump method which will sometimes pull the tool out a little breaking it off.
Please let me know Scotty...if not, I'll order another...sigh
01-22-2010, 07:48 PM #7
I will look in the morning I think I still have it.
01-22-2010, 07:54 PM #8
01-23-2010, 05:13 PM #9
No luck Mike.I didn't give you one already did I ?
I found my 65U tools but not the smaller one.
01-23-2010, 06:23 PM #10
Mike, when it comes to pump, props, and tools, I am lost.
Do you need to tool you sent me with the prop?
If so, I can send it right on back to you. I won't need it for a few more months,,,,,,,I hope.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)