Results 1 to 3 of 3
  1. #1
    Banned User
    Join Date
    Aug 2009
    Location
    Discovery Bay, CA
    Posts
    3,048
    +1
    336

    one question always leads to another

    so i really want to pull the trigger on a pump extension for my 08 px and want to do it right the first time. i've been doing a lot of reading up on them and it seems like it would also be a great time to put in a Piranha solid front motor mount since ill have to align the motor with the extension install. kinda kill two birds with one stone. the two questions i've come up with that i cant seem to to find an answer for using the search button are...

    1. where do i find the shims for the motor mount. i've read they sell them in .3mm and 1.3mm sizes and i should probably get a few of each to get the job done. i spent quite a bit of time looking in the oe replacement parts store and can't find them in there anywhere.

    2. would i need a new carbon ring? i wasn't sure if they wear to the driveshaft or how that works. i figure most likely not since the riva directions don't say anything about it but hey only dumb question is the one not asked. as of now i have 35hrs on the original on so i'm sure its fine.

    anyways thats all i got for now!
    thanks
    mike


  2. #2
    Nothin' better than Doo'in it! BigDaddyRXP's Avatar
    Join Date
    Aug 2007
    Location
    Tampa Bay, FL
    Posts
    9,202
    +1
    673
    Part # 4 & 13

    http://partsfinder.onlinemicrofiche....e=13&A=161&B=5

    Stainless or aluminum shim stock can also be cut to size, and used if needed.

    Your carbon ring will be fine!

  3. #3
    Banned User
    Join Date
    Aug 2009
    Location
    Discovery Bay, CA
    Posts
    3,048
    +1
    336
    man you just gotta laugh at yourself when you stare at something for so long and can't find it, then someone comes along and points out it was right under your nose the whole time. thanks big daddy!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. labor involved in cylinder and piston swap from one ski to another
    By skibob in forum Yamaha Open Discussion
    Replies: 0
    Last Post: 06-20-2016, 09:17 AM
  2. Replies: 5
    Last Post: 01-21-2013, 11:14 PM
  3. From one adrenaline junkie to another
    By RXPED in forum 4-Tec Performance
    Replies: 11
    Last Post: 09-01-2006, 12:13 AM
  4. Riva Stage One Question?
    By RxPrider in forum 4-Tec Performance
    Replies: 5
    Last Post: 08-25-2006, 04:07 PM
  5. Any one in here going to Lake Norris????
    By two2curupt in forum Sea Doo Open Discussion
    Replies: 4
    Last Post: 02-18-2006, 09:46 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •