01-27-2010, 11:29 PM #1
rude 2 sc can run riva 50ib injector
hi ! some question ask ? i am run riva ECU and rude 2 sc , can use the riva 50ib injector?????
seadoo rxt-t 255 use rude 2 sc , 4" intake , R&D gate , open loop, riva water, riva valve train, 15/22r impeller, wear ring ss, reduction nozzla 83mm, worx sponson, 50ib injector, intake block-off kit, rude rrfpr, intercooler upgrade kit , riva blow-off kit, riva cluth washer.
01-28-2010, 12:09 AM #2
Short answer is no.
You should have additional fueling.
01-28-2010, 12:10 AM #3
01-28-2010, 12:11 AM #4
01-28-2010, 07:38 AM #5
01-28-2010, 07:38 AM #6
riva ecu and 50s are good for 14 psi ..after that you need additional fueling..the rrfpr..should do it and then some
01-28-2010, 08:53 AM #7
YES you can..I am currently running a 2 rude with 50 lbs injectors..Like the other guys said you will need either a fuel controller or RRFPR, But you can run it with 50s..
01-28-2010, 09:29 AM #8
+1 on the above info.
I would also upgrade the fuel pump at this point, too.
01-28-2010, 10:56 AM #9
01-28-2010, 04:53 PM #10
Buy a afr gauge,i myself use the innovate.
Just to be sure,afr depends on temperatures and humidity.
What might work in summer,blows up in winter due to a bad afr.
The hotter it gets the higher your afr will be.
The rrfpr is ideal for tuning your afr to a optimum, best is 11.8.
As mentioned above by others riva works to 14 psi with the 50's.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By JFizzleJR in forum 4-Tec PerformanceReplies: 27Last Post: 12-06-2007, 04:31 PM
By breon in forum 4-Tec PerformanceReplies: 5Last Post: 11-08-2007, 12:29 AM
By mstennes in forum 4-Tec PerformanceReplies: 30Last Post: 09-16-2007, 08:36 PM
By ARNYGOLLOTT3 in forum 4-Tec PerformanceReplies: 69Last Post: 09-05-2007, 11:27 PM
By GeoRXT in forum 4-Tec PerformanceReplies: 28Last Post: 08-26-2007, 02:57 PM