Thread: 785 cylinder
01-28-2010, 10:15 PM #1
Can this little spot on the top of the cylinder be repaired?. it's on the top edge
01-28-2010, 10:21 PM #2
On a side note about the 785 cylinder since were talking about it..I see in the pic there the exhaust port for the valve. looks rough. could that be polished since its on the exhaust side and not the intake?
Also, Could someone tell me which ports are which. i see the 2 next to the valve exhaust. theres 1 above those . is that the intake from the carbs? and the other two are exhaust? Just curious what im looking at. I could post a few more pics too.
01-28-2010, 10:53 PM #3
A resleeve would fix that. It looks like it is just into the sleeve and not into the cylinder.
01-28-2010, 11:17 PM #4
Hey your back! Couldnt it be filled n sanded? why a whole resleeve? or is that the only way to fix it?
01-29-2010, 06:46 AM #5
If the ding it above where the top ring stops you should be good to go. This set of cylinders is sleeved stock 785's are plated as stated.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By WIslxer in forum Polaris PWC PerformanceReplies: 11Last Post: 09-28-2007, 01:14 PM
By TILERYBOY2 in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 09-03-2007, 06:40 AM
By kennymack in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 08-16-2007, 12:48 PM
By GP1300r110 in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 07-28-2007, 03:25 PM
By beerdart in forum Polaris Open DiscussionReplies: 1Last Post: 07-11-2007, 12:21 PM