09-05-2006, 09:31 AM #1
Charging. What voltage/MFD problem
What should the volt meter read on a SLT 750…mine reads 14.5 with the craft off and 17.5 to 18 while running….could this be causing my MFD problems?
If I disconnect the battery for a couple of hours and then reconnect it the MFD works fine for the first ride. The next day it’s just stuck in time mode and will not come out of it…ride on for a bit and the display goes blank. Disconnect the battery again for a few hours and the cycle begins again.
09-06-2006, 12:23 AM #2
Way too high, check all grounds and if they are good and clean, replace the voltage regulator.
Oh verify the actual voltage with a volt meter first.
09-06-2006, 04:22 AM #3
Yes, as Al stated, verify first. If those numbers are real... it's way too high!
09-06-2006, 08:48 AM #4
I will have to wait until spring to check this more thoroughly….she is already put to bed for a long winters nap
09-06-2006, 09:42 AM #5Originally Posted by 2kids3pets
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By old guy in mich in forum Polaris Open DiscussionReplies: 20Last Post: 04-30-2008, 01:58 PM
By explude in forum Polaris How To & FAQsReplies: 5Last Post: 04-12-2008, 02:27 PM
By 32DegH2O in forum Polaris Open DiscussionReplies: 15Last Post: 07-12-2007, 12:58 PM
By Mongoose in forum Yamaha Old School SkisReplies: 6Last Post: 07-07-2007, 03:33 AM
By NateGP1300R in forum Yamaha PWC Performance (2-stroke)Replies: 33Last Post: 07-29-2006, 08:08 PM