Results 1 to 4 of 4
  1. #1
    2006 RXP
    Join Date
    Jun 2007
    Location
    Baltimore MD
    Posts
    59

    Braided tube install --how do i ensure a good fit?

    Just got a set of braided replacements for the vent tubes on my RXP, these things looks slightly bigger than the tubes they are replacing.... how do i ensure a proper fit here? i dont even think the tube ends will fit into the holes the original tubes begin/end in.

    any ideas?


  2. #2
    West Texas RXP skoepp's Avatar
    Join Date
    Oct 2007
    Location
    west texas
    Posts
    12,019
    +1
    149
    Quote Originally Posted by bblades262 View Post
    Just got a set of braided replacements for the vent tubes on my RXP, these things looks slightly bigger than the tubes they are replacing.... how do i ensure a proper fit here? i dont even think the tube ends will fit into the holes the original tubes begin/end in.

    any ideas?
    Are they the riva's. IF so they will fit. It is a pita getting them in but can be done. Put them in the front first, slide it as far forward as you can, then put in rear and move into place.

    It is very tight but can be done.

  3. #3
    2006 RXP
    Join Date
    Jun 2007
    Location
    Baltimore MD
    Posts
    59
    Quote Originally Posted by skoepp View Post
    Are they the riva's. IF so they will fit. It is a pita getting them in but can be done. Put them in the front first, slide it as far forward as you can, then put in rear and move into place.

    It is very tight but can be done.
    thanks!

  4. #4

    Join Date
    Jan 2008
    Location
    mishawaka,in
    Posts
    58
    I had to shorten mine on my 05 rxp would not lay down flat

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How do you install a fuel water separator??
    By LakeDog in forum Yamaha PWC Performance (2-stroke)
    Replies: 5
    Last Post: 06-16-2009, 09:38 PM
  2. How do I install...
    By HallPass in forum Yamaha Old School Skis
    Replies: 4
    Last Post: 01-18-2008, 06:13 PM
  3. How do I check MPEM, engine not installed
    By Skripo in forum 2-Stroke Performance
    Replies: 2
    Last Post: 08-29-2007, 07:48 AM
  4. how do i install a boost gauge on a 03 gtx?
    By FL03GTX in forum 4-Tec Performance
    Replies: 0
    Last Post: 08-20-2007, 03:00 PM
  5. how do i install a boost gauge on a 03 gtx?
    By FL03GTX in forum 4-Tec Performance
    Replies: 1
    Last Post: 08-20-2007, 02:26 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •