Thread: prop tools
09-05-2006, 11:08 AM #1
I'll be installing my stg. 1 kit soon after the 10 hr service. when I replace the prop...do I need both a solas & oem removal tool?? or will one or the other work?? I just saw 2 tools in Jerry's store, just wanted to know if I needed both. Also do i need those hex tools as well or are they optional???
09-05-2006, 11:09 AM #2Originally Posted by sourpower RXT
The Solas or OEM tool will work, they fit on the splines of the impeller the same way.
Get the cheaper one and you are good to go.
09-05-2006, 11:13 AM #3
You are also going to need a 12 mm allen wrench, not something in a common allen wrench set, Sears is where I finally found one.
09-05-2006, 11:33 AM #4
I had to use a long pipe with the 12mm Allen wrench. Some people have cut it down and inserted it into a 12mm 1/2"-drive socket then used a breaker bar. Don't use an impact wrench.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By bruinsrme in forum 4-Tec PerformanceReplies: 1Last Post: 10-29-2007, 02:39 PM
By GeoRXT in forum Sea Doo Open DiscussionReplies: 14Last Post: 08-27-2007, 12:12 PM
By BJTKRXPHD in forum Sea Doo Open DiscussionReplies: 2Last Post: 07-28-2006, 08:09 AM
By BJTKRXPHD in forum 4-Tec PerformanceReplies: 1Last Post: 07-27-2006, 09:27 PM
By BJTKRXPHD in forum 4-Tec PerformanceReplies: 4Last Post: 07-24-2006, 02:32 PM