Thread: Reducing Ring for RXT-X
02-18-2010, 01:47 PM #1
Reducing Ring for RXT-X
I'm going to be have my pump nozzle machined to accept the Riva reducing rings and I'm looking for a suggested size to go with for my set up listed below:
RXT-X with stock impeller
-4" Kanaflex intake / filter
-Flame arrestor removed
-Ride Plate holes filled
-Reverse bucket Mod
-Competition O.P.A.S Kit
02-18-2010, 02:04 PM #2
I would not go below 85, I found this one to not kill the hole shot to bad
I tried a 83 and thought it was a dog out of the hole
02-18-2010, 02:05 PM #3
I have a Riva stg 1 and I have been running the 82mm, seems to be a good combo of acceleration and speed.
02-18-2010, 02:09 PM #4
anybody know what the stock diameter measures out to?
02-18-2010, 02:12 PM #5
02-18-2010, 03:28 PM #6
Pretty sure you cannot have the X nozzle modified nas it is alot shorter than the RXP nozzle, the 2 suction pipes from the bailers are in the way in the X nozzle. R88
02-18-2010, 05:29 PM #7
Why not just buy a stock RXP 215 ring, 83mm? Aren't they only about 100 bucks? I run an 82mm and still seems to have strong hole shot with a 15/22R. I wouldn't mess with machining your stock nozzle.
03-02-2010, 10:38 AM #8
03-02-2010, 10:46 PM #9
Many of us including myself have swapped our P-X's to a stock rxp nozzle which is around 83.
03-03-2010, 09:20 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By PuprleNuprleGPR in forum Yamaha PWC Performance (2-stroke)Replies: 28Last Post: 09-25-2007, 11:21 AM
By lafjax in forum 4-Tec PerformanceReplies: 6Last Post: 04-11-2007, 04:48 PM
By VaRedneck in forum 4-Tec PerformanceReplies: 7Last Post: 03-22-2007, 06:42 PM
By Kinchyle in forum 4-Tec PerformanceReplies: 5Last Post: 08-03-2005, 09:36 PM
By kenshin89 in forum 4-Tec PerformanceReplies: 4Last Post: 07-24-2005, 11:21 AM