Thread: Set of 3 66V Carbs for 1200PV
02-19-2010, 07:46 AM #1
Set of 3 66V Carbs for 1200PV
Sorry Sold.....This is a set of carbs for a Yamaha 66V motor. They are in mint condition bordering on "NEW". The carbs are fine and Osidebill sent a good manifold for them. These carbs have an accelerator pump line to all three, not just two that you usually see. The carbs still have the thick yellow grease used from the factory.
The jet and n/s sizes are as follows 117.5/87.5 & 1.2.
I took one carb apart so you can see how clean they are inside.
There is abosultely no corrosion on these carbs in or out. They are MINT.
$350.00 Shipped to Lower 48/ International will be more.
Last edited by smacota1; 03-16-2010 at 02:23 PM. Reason: add pic
02-20-2010, 10:19 PM #2
I believe these have never had any fuel in them. They have been sitting on a shelf for several years......satisfaction or full refund (less shipping)
02-20-2010, 10:39 PM #3
I have a spare manifold, if you would like it pm me your address. all I ask is cover the shipping.
The three accel lines were common on the export models, then they started appearing in the later model XLT's in the US.
I would have to agree on the no fuel through them they look new, even has the mark on the check valve. This dissapears once fuel is run through them.
02-21-2010, 08:57 PM #4
Lowering price to $385.00 shipped to lower 48.
02-23-2010, 09:16 AM #5
02-26-2010, 04:39 PM #6
New Price and good manifold provided by Osidebill.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By RX951 in forum Yamaha Open DiscussionReplies: 5Last Post: 04-10-2008, 02:03 PM
By Skips313 in forum Kawasaki Tech Tips and InfoReplies: 0Last Post: 12-23-2007, 08:42 AM
By Jolly Roger in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 07-30-2007, 08:25 PM
By Chezzy in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 01-22-2007, 04:28 PM
By Chezzy in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 01-20-2007, 06:47 PM