Thread: Supercharger Removal?
09-08-2006, 09:07 AM #1
Did a search but can't seem to find anything. Anybody know where to find a good "how to" on removing one of these things? Thanks for any help.
09-08-2006, 12:52 PM #2
Very simple. Remove hose from SCer to intake. BUY two new clamps to replace thoses.
Remove the intake hose to the SCer. Set aside.
Remove the cooling hose from the Exhaust manifold to J pipe that goes in the waterbox.
Remove the Clamp to the J pipe that connects the J pipe to the exhaust manifold.
Remove Waterbox strap and pull water box and J pipe back about 3to 4 inches.
Then remove the three hex screws to the SCer, 1 on the back and two on the front. The one you can see on the back you will have to use a 1/4 inch boxed end ratching wrench.
Hope this helps. I will find the Riva post that will help you also.
09-08-2006, 12:58 PM #3
Here ya go. This is to put the vortec Impeller in, so you may use theses instructions. It shows you how to do it all. And just skip the part about pulling the SCer apart for the New vortec impeller.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By pito in forum 4-Tec PerformanceReplies: 2Last Post: 05-23-2007, 01:10 PM
By 98Hawk in forum Sea Doo Open DiscussionReplies: 6Last Post: 04-18-2007, 03:42 PM
By badams7 in forum Sea Doo Open DiscussionReplies: 4Last Post: 03-08-2007, 01:21 AM
By Totallyblown in forum Sea Doo Open DiscussionReplies: 9Last Post: 04-28-2006, 07:37 AM
By Griff350 in forum 4-Tec PerformanceReplies: 16Last Post: 01-05-2006, 06:16 PM