Results 1 to 6 of 6

Thread: Prop Swapping

  1. #1

    Prop Swapping

    Im a bit of a amateur at modding and mechanics, I know tools and I can follow directions great. It took me a little less than 90 mins to remove my supercharger effectively. How difficult is it to switch my prop out? I have read the GH post on how to. Just wondering everyones personal opionion


  2. #2
    Moderator Snoman's Avatar
    Join Date
    Apr 2006
    Location
    South Chicagoland
    Posts
    14,688
    +1
    846
    It is as easy as reading the directions..IMO its just as easy to change the prop as it is pulling a Scer as long as you have the right tools...

  3. #3
    Mod less, ride more! troyheb's Avatar
    Join Date
    Jul 2007
    Location
    Nederland, Texas
    Posts
    8,725
    +1
    1,267
    Quote Originally Posted by Snoman View Post
    It is as easy as reading the directions..IMO its just as easy to change the prop as it is pulling a Scer as long as you have the right tools...
    +1 Have the right tools and it is very easy.

  4. #4
    Sounds good. Thanks guys. any odd problems you guys ran into or was it pretty smooth.

  5. #5
    Moderator Snoman's Avatar
    Join Date
    Apr 2006
    Location
    South Chicagoland
    Posts
    14,688
    +1
    846
    It goes pretty smooth unless your wear ring is grooved badly..But even then all you do is loosen the prop,stick the pump in the freezer for 20 min and it will all pull out..Other than that thats about the worst your deal with..

  6. #6
    home of the dislexic fingers breon's Avatar
    Join Date
    Aug 2007
    Location
    port st lucie fl
    Posts
    3,471
    somple job the hardes part is getting the nose cone off ..very thing blae screw driver...when reassembling dont use the 17 mm bolts to pull the pump in just spray a little silicone on the gasket /seal and it should slide in buy hand...start all your bolt buy hand and should b good to go ...use blue loctight on all stearing stuff...don ask how i know seadoo does land on youtube a couple of years ago

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How-to: Pump Pulling - Wear Ring Swap - Prop Swapping
    By Green Hulk in forum Sea Doo How To & FAQs
    Replies: 160
    Last Post: 07-28-2014, 07:29 PM
  2. Replies: 13
    Last Post: 10-06-2011, 04:51 PM
  3. rxp-x wont idle after prop swap
    By lightning666 in forum 4-Tec Performance
    Replies: 9
    Last Post: 03-19-2010, 03:47 PM
  4. Prop Swap
    By Xman in forum 4-Tec Performance
    Replies: 2
    Last Post: 12-10-2009, 07:05 AM
  5. 2001 prop swap with 2005 1300r
    By Hydrotherapy in forum Yamaha PWC Performance (2-stroke)
    Replies: 5
    Last Post: 11-07-2006, 12:52 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •